Make a Cool Wooden Stool with Spider X1

Wooden stools are essential furniture for every home, but most of them are not beautiful enough. That being the case, let’s make a beautiful and practical wooden stool by yourself! No woodworking skills are required, only a Spider X1 and wood materials are needed, and it can be easily completed.

About Spider X1, you can know more details from Kickaterter.

Equipment: Spider X1 20W
Engraving format: 800mm-1400mm (extension frame*2)
Product size: 800mm*430mm
Board thickness: 8mm
Board Type: Household Plywood
Engraving speed: 200mm/min,
Power: 100%
Air assist: 40L/min (550W air compressor)

At the bottom of this page, you can download the GCode file that we have preset for you, and the original LightBurn file is also included in the compressed package (The version of LightBurn we are using is 1.4, you can also use “.dxf” files if you cannot open “.Ibrn2” files). The effect picture in LightBurn and the actual cutting effect is as follows:

Wooden Stool

Actual cutting effect

After the machine cutting is complete, follow the steps below for final processing:

1. Adhesive two layers of board with wood glue, from a single layer of 8mm to double layers of 16mm

2. Use a woodworking trimming machine, with R3.97 and R7.96 fillet knives, round the edge and remove black edges.

3. Assemble according to the holes on the parts.

4. Coloring with acrylic paint. Then you finally complete the wooden stool.

You can also watch our instructional video (Note that the drawings in the video are wrong, please refer to the drawings attached to this article.):

If you would like to know more about Spiderlasers, you can click here to visit their website.